Garrett's Mindless Rambling

Not Just another WordPress site

Juniper

Setup Juniper OSPF

Garrett

The following is how to setup basic OSPF for route sharing in a network. This uses the area of 0.0.0.0 and uses em5 as the interface.

  1. Enable OSPF in area 0.0.0.0 on interface em5.0.
    • set protocols ospf area 0.0.0.0 interface em5.0

Leave a Reply

Your email address will not be published. Required fields are marked *

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Back To Top